Xantrex Freedom XC 2000 User Manual

Basic Installation Procedures
975-0784-01-01 37
Figure 12 Ignition signal (ACC) input terminal
5. Using a 3mm slot long neck screwdriver, push into the
rectangular slot to release the spring clamp.
6. Insert the ignition control wire into the round ACC input
terminal slot.
7. Pull the screwdriver out to engage the spring clamp and
secure the wire to the terminal.
Description of Ignition Control Features
For information about the features and instructions on changing
the ignition control features, see Operation on page 43.
Ignition Auto-
on (ATO)
This setting allows the inverter/charger to
operate (Battery mode) automatically
when an ignition control wire is connected
to the ACC input and a valid ignition
signal is constantly detected. The inverter
works in tandem with the vehicle’s ignition
circuit.
Ignition Lock-
out (LOt)
This setting allows the inverter to operate
(Battery mode) when an ignition control
wire is connected to the ACC input
terminal and a valid ignition signal is
constantly detected.
When enabled, you have to manually
press the Power button on the display
panel to operate the inverter.
Off (OFF)
To completely disable the ignition control
features do the following:
Set Ignition Control to Off (OFF) using the
Select buttons on the Display panel.
Table 10Ignition Control Features

Xantrex Freedom XC 2000 Specifications

General

Continuous Power	2000W
Surge Power	4000W
Input Voltage	12V DC
Output Voltage	120V AC
Output Frequency	60 Hz
Waveform	Pure Sine Wave
Efficiency	90%
Operating Temperature	-4°F to 140°F (-20°C to 60°C)
Transfer Time	20ms