Before You Begin the Installation
14 Freedom XC Owner's Guide
Before You Begin the
Installation
Before beginning your installation:
n Read this entire Installation section so you can plan the
installation from beginning to end.
n Assemble all the tools and materials you require for the
installation.
n Review the Important Safety Instructions on page vii
n Be aware of all safety and electrical codes which must be
met.
WARNING
ELECTRICAL SHOCK AND FIRE HAZARD
n All wiring should be done by qualified personnel to ensure
compliance with all applicable installation codes and
regulations.
n Do not connect to AC and DC power sources during
installation. Disconnect from all power sources when
servicing.
n Disable and secure all AC and DC disconnect devices
and automatic generator starting devices.
Failure to follow these instructions can result in death, serious
injury, or equipment damage
Installation Codes
Governing installation codes vary depending on the specific
location and application of the installation. Some examples
include the following:
n The U.S. National Electrical Code (NEC)
n The Canadian Electrical Code (CEC)
n The U.S. Code of Federal Regulations (CFRs)
n Canadian Standards Association/CSA Group (CSA) and the
RV Industry Association (RVIA) standards and codes for
installations in RVs
n The American Boat and Yacht Council (ABYC) standards
and US Coast Guard Regulations (33CFR183, Sub Part I)
for Marine installations in the U.S.
It is the installer’s responsibility to ensure that all applicable
installation requirements are met.
To Next Page
Loading...
Need help?
General
