8 Safety Notes
Stop operation immediately if your machine
produces smoke, excessive heat, unusual
noise, or smell, or if water is spilt onto the
machine. These conditions can cause fire.
Immediately switch off and unplug the
machine, and contact our Customer
Support Center or your dealers.
To prevent fire or electric shock, connect
the machine to an outlet that has the
correct rating and correct grounding. If in
doubt, contact our Customer Support
Center or your dealers.
If the power cord is broken or insulated
wires are exposed, ask our Customer
Support Center or your dealers for a
replacement. Using a damaged cord can
cause fire or electric shock.
Do not unplug or replug the machine while
it is on. Unplugging a live connector can
deform the plug and cause fire.
When unplugging the machine, grasp the
plug instead of the cord. Forcibly pulling on
a cord can damage it and cause fire or
electric shock.
Be sure to switch off and unplug the
machine before accessing the interior of
the machine for cleaning, maintenance, or
fault clearance. Access to a live machine’s
interior can cause electric shock.
When the machine is not used over an
extended period of time, switch it off and
unplug it. If an unused machine is left
connected to a power source for a long
period, degraded insulation can cause
electric shock, current leakage, or fire.
Once a month, unplug the machine and
check the power cord for the following:
• The power cord is plugged firmly into a
receptacle.
• The plug is not excessively heated,
rusted, or bent.
• The plug and receptacle are free of dust.
• The cord is not cracked or frayed.
If you notice any unusual conditions,
contact our Customer Support Center or
your dealers.
Switch off the machine before connecting
the interface cable or optional product.
Connecting the cable or optional product
with a live machine can cause electric
shock.
For Machine Operation
Do not place any liquid container such as a
vase or coffee cup on the machine. Spilt
water can cause fire or electric shock.
Do not place any metal parts such as
staples or clips on the machine. If metal
and flammable parts get into the machine,
they can short-circuit internal components,
and cause fire or electric shock.
If debris (metal or liquid) gets into the
machine, switch off and unplug the
machine. Contact our Customer Support
Center or your dealers. Operating a
debris-contaminated machine can cause
fire or electric shock.
Never open or remove machine covers that
are secured with screws unless specifically
instructed in the manual. A high voltage
component can cause electric shock.
Do not try to alter the machine
configuration, or modify any parts. An
unauthorized modification can cause
smoke or fire.
This equipment is certified as a Class 1
laser product under IEC60825-1 (Class 1).
This means that the machine does not emit
hazardous laser radiation. Since radiation
emitted inside the machine is completely
confined within the protective housings and
external covers, the laser beam cannot
escape from the machine during any phase
of user operation. Do not perform any
operation apart from the instructions given
in the manual. There may be a danger of
laser beam leakage.
To Next Page
Loading...
