Refer to note 4 belowLEFLabels
Refer to note 2 belowSEF
LEFGBC brand or pre-punched with
rectangular holes: (holes on long
edge). This type of paper only works
when holes are at the rear of the pa-
per tray.
Refer to note 4 below (Load with
holes AWAY from user.)
SEF
Never Tear Type
Drafting Film
Perforated:
Refer to note 5 belowPerforations parallel to feed direction
Refer to note 5 belowPerforations perperdicular to the
feed direction
Envelopes(standard medium to large
lettersize)
Tabs
Carbonless
Refer to note 7 belowTextured papers, Vellum Bristol pa-
pers
Smooth cover index stock
Table Legend
• SEF: Short Edge Feed
• LEF: Long Edge Feed
• Best: Best system performance
• Good: Good system performance
• Fair: Significant performance degradation is likely, particularly paper handling.
• **: Same performance as shown in 20 lb. Standard Paper Table for the corresponding paper sizes.
Notes:
1. The output will go to the Top Tray in an MFF-equipped machine, and cannot be stapled.
2. Refer to Table 5 or to the paper tray label for the correct paper loading orientation.
3. Embossed letterhead may cause degraded paper handling, and possibly image deletion defects
near the embossed area on either side of the paper.
10-5Xerox
®
Nuvera
®
User Guide and Training Aid (UGTA)
Expected Paper Handling
To Next Page
Loading...
Need help?
General