4. If needed, add 8.5x11 white stock to tray 3 or 4. Place stock to short edge feed. Verify tray
programming.
5. Program Job properties. For example:
a. In the user interface on the Basic tab, select Trifold C from the Finishing menu.
b. Make any other job programming choices.
6. When satisfied with your settings, click Copy.
To make a Z-Folded document while copying
1. Place the original document in the Document Feeder, short edge feed, side one face up with the top
of sheet toward the back of the scanner.
2. Select Copy Services.
3. Select Clear All.
4. If needed, add 8.5x11 white stock to tray 3 or 4. Place stock to short edge feed. Verify tray
programming.
5. Program Job properties. For example:
a. In the user interface on the Basic tab, select Trifold Z from the Finishing menu.
b. Make any other job programming choices.
6. When satisfied with your settings, click Copy.
To make a Folded document while printing
The steps for printing a Folded document are essentially the same as they are for copying. The only
difference is that you will browse to find the print-ready file at the Xerox Nuvera .
For details on printing from the CD ROM drive, see Printing from the Media Drive.
For details on printing from your PC, see Printing a Job from your Networked PC.
Using the Basic Finishing Module (BFM)
The Basic Finishing Module (BFM) is a high-capacity stacker designed to collate and stack up to 3000
sheets (20 lb paper or equivalent) and staple up to 100 sheets of 20 lb (75 gsm).
Select the BFM or BFM Plus finisher as the output device
1. Select the Output tab from a Job or Queue Properties window.
2. Select the Stapling/Finishing FAB.
3. From the Output Location pull-down menu, select the output device as: -System Specified -Auto
Switch -Finisher A or B: Main Stacker -Top Tray
4. Select the single or dual stapling from the Stapling/Finishing pull-down menu.
5. Select OK.
14-17Xerox
®
Nuvera
®
User Guide and Training Aid (UGTA)
How Do I...
To Next Page
Loading...
Need help?
General