Xerox Phaser 3150

Disassembly
5-20
5.14 Drive Assembly
1. Remove the front cover, see "5.2 Front Cover" on page 5-3.
2. Remove the rear cover, see "5.4 Rear Cover" on page 5-5.
3. Remove the top cover, see "5.5 Top Cover" on page 5-6.
4. Remove the left and right covers, see "5.7 Side Cover (Left and Right)" on page 5-8.
5. Remove the 6 screws securing the drive assembly.
Note
The drive assembly screws are numbered and need to be tightened down in the correct order
when reassembling.
6. Disconnect 1 connector from the drive assembly to remove the drive.
Drive Ass'y
Drive Ass'y