Installation and Setup
Phaser 6600 Color Printer 35
User Guide
Removing the Wireless Network Adapter
1. Turn off the printer.
2. Unscrew the thumbscrew on the back of the left door, then open the left door.
3. Locate the plastic latch release on the Wireless Network Adapter protruding through the back of
the chassis.
4. Reach into the chassis and push inward, then back on the latch release.
CAUTION: Do not use force to pull on the Wireless Network Adapter. If the latch is released
properly, the adapter pulls out easily. Pulling on the adapter can damage it.
5. Close the left door, then screw in the thumbscrew on the back of the door.
6. Connect the printer to your computer with a USB cable or through the network using an Ethernet
cable.
7. Turn on the printer.
Resetting Wireless Settings
If the printer was previously installed in a wireless network environment, it could retain setup and
configuration information.
To prevent the printer from trying to connect to the previous network, perform the following steps:
1. At the printer control panel, press the Menu button.
Note: To navigate through the menu, use the Up or Down arrow buttons.
2. Navigate to Admin Settings, then press OK.
3. Navigate to Network Setup, then press OK.
4. Navigate to Wi-Fi Setup, then press OK.
5. Navigate to Reset Wi-Fi, then press OK.
6. To confirm, press OK.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
