Discovery Protocols
System Administrator Guide
2-7
UPnP (Universal Plug and Play)
UPnP provides a simplified method to obtain an IP Address for a printer, locate devices on the
network, and display those devices on desktop computers.
1. Launch your web browser.
2. Enter your printer’s IP address in the browser’s Address field (http://xxx.xxx.xxx.xxx).
3. Click Properties.
4. Click the Protocols folder on the left navigation panel.
5. Select TCP/IP.
6. If prompted, enter your Admin or Key User name and password.
7. Under Universal Plug and Play (UPnP) Settings, in the Auto IP Enable field, select On
or Off.
8. Select On or Off for SSDP Enable:
■ On: will enable the printer to send and receive Simple Device Discovery Protocol
announcements and requests.
■ Off: The printer will not issue nor respond to SSDP requests.
9. Set the SSDP TTL value. This value specifies the multicast radius, often referred to as
hop count or time-to-live, for SSDP. The valid range is between 0-255.
10. Click the Save Changes button.
To Next Page
Loading...
General
Weight and Dimensions
