2. Adjust the paper length and width guides as shown.
3. Flex the sheets back and forth and fan them, then align the edges of the stack on a level surface. This
procedure separates any sheets that are stuck together and reduces the possibility of jams.
4. Load paper into the tray with the print side face up.
• Load hole-punched paper with the holes to the left.
• For 1-sided printing, load letterhead paper face up with the top of the paper toward the back of the tray.
• For 2-sided printing, load letterhead and pre-printed paper face down with the top edge going into the
printer.
Note: Do not load paper above the maximum fill line. Overfilling the tray can cause the printer to jam.
5. Adjust the length and width guides to fit the paper.
Xerox
®
VersaLink
®
B400 Printer User Guide 105
Paper and Media
To Next Page
Loading...
