Xerox VersaLink B7030 - Set Ipsec; Set Overwrite Hard Disk

Xerox
®
VersaLink
®
B7025/B7030/B7035 Multifunction Printer
Security Function Supplementary Guide
23
Set IPSec
Before setting Digital Signature for IKE Authentication Method , you need to import an IPSec
certificate according to the same procedure as "Import Machine Certificates".
1.
Select Connectivity .
2.
Select IPSec .
3.
Enable IPSec
4.
Select Preshared Key or Digital Signature for IKE Authentication Method.
5.
When you select Preshared Key , enter a preshared key of 9 or more characters in Preshared Key and
Retype Preshared Key .
When you select
Digital Signature , select the certificate name in Device Certificate .
6.
Enter the IP Address in Specify Destination IPv4 Address.
7.
Enter the IP Address in Specify Destination Ipv6 Address.
8.
Select Enabled or Disabled for Communicate with Non-IPSec Device.
9.
Select OK .
10.
Select Restart Now if prompted.
Set Overwrite Hard Disk
Follow the procedure below to configure the Data Overwrite settings.
This feature is only applicable to HDD Model.
1.
Select System .
2.
Select Security .
3.
Select Edit for Disk Overwrite.
4.
Enable Data Overwrite After Job Completion .
5.
Select OK .
6.
Select Restart Now if prompted.