Xerox
®
VersaLink
®
B7025/B7030/B7035 Multifunction Printer
Security Function Supplementary Guide
38
Problem Solving
This section describes solutions to problems that you may come across while using the machine
and
Embedded Web Server
. The machine has certain built-in diagnostic capabilities to help you
identify problems and faults, and displays error messages on the control panel and web browser,
whenever problems or conflicts occur.
Fault Clearance Procedure
If a fault or a problem occurs, there are several ways in which you can identify the type of the fault.
Once a fault or a problem is identified, specify the probable cause, and then apply the appropriate
solution.
If a fault occurs, first refer to the screen messages to clear the fault according to the specified order.
Also refer to the fault codes displayed on the touch screen in the Machine Status mode.
Refer to the Fault Codes table below for an explanation of some fault codes and corresponding corrective actions.
When you have problems in fixing the fault, contact a System Administrator for assistance.
In some cases, the machine may need to be turned off and then on.
NOTE :
You should call for service representative if the problem persists or a message indicates so.
Even when the power of the machine fails, all the queued jobs will be saved because the machine is equipped
with the storage device. The machine will resume processing the queued jobs when the power of the
machine is turned back on.
To Next Page
Loading...
Need help?
General
