Detailed Specifications Xerox
®
Versant™ 2100 Press
Customer Expectation and Installation Guide Xerox Confidential 20
Combination of Output Functions and Destinations
Table Legend: O: Can be combined X: Cannot be combined
Function/ Combination of Functions SquareFold Functions
Output Destination
Booklet Trimmer
Square Fold
Booklet Tray
Trimmer Booklet Tray
Offset X X
X
X
X
Staple X X
X
X
X
Punch X X
X
X
X
Interposer O O
O
O
O
Booklet - O
O*1
O
O
Z-Fold X X
X
X
X
Letter Fold X X
X
X
X
Bi-Fold - O
O*1
O
O
Offset X X
X
X
X
Staple + Z-Fold X X
X
X
X
Staple + Interposer X X
X
X
X
Punch + Z-Fold X X
X
X
X
Z-Fold + Interposer X X
X
X
X
Staple + Puncher + Z-Fold X X
X
X
X
Staple + Punch + Z-Fold + Interposer X X
X
X
X
*1: Square-folding/trimming of non-stapled sets and square-folding of 4 or less sheets in a set are outside the specification and cannot be assured. Jams may
occur frequently or wrinkles may occur on the square-folded side of paper.
SquareFold Trimmer Skew Specification
Booklet + trimming Measure both sides of the bottom sheet when the booklet is output.
Staple: |L5-L6| ≤ 2 mm (Achievement rate: 95%)
Bi-Fold/Non-staple: |L5-L6| ≤ 3 mm (Achievement rate: 95%)
Booklet + trimming + square-folding Measure both sides of the bottom sheet when the booklet is output.
Staple: |L7-L8| ≤ 2.5 mm (Achievement rate: 95%)
Performance is not guaranteed at Bi-Fold/Non-staple.
Standard Finisher Plus
The Standard Finisher Plus provides the same functions as the Standard Finisher, although Stacker Tray capacity is reduced from 3,000 sheets to a
maximum of 2,000 sheets. The Standard Finisher Plus adds a Finishing Transport module which enables connection to available third-party finishing
solutions.
NOTE: A Standard Finisher cannot be upgraded to a Standard Finisher Plus. Finishing solutions that can be connected to the Standard Finisher Plus
include:
Plockmatic Pro 35/50 Booklet Maker
GBC E-Bind.
Specifications and expectations for these devices are available in a Solutions Planning Guide which is available from your Xerox sales representative or
analyst.
Standard Finisher Plus
Specifications
For information related to the Standard Finisher Plus, refer to Module Dimensions for Optional Devices.
To Next Page
Loading...
