Xerox WorkCentre 5020DN - Changing the Size and Orientation of Paper in Tray 2

Changing the Size and Orientation of Paper in the Trays
47
Changing the Size and Orientation of Paper in Tray 2
The following procedure describes how to change the size and orientation of paper in
Tray 2.
1. Pull out Tray 2 towards you.
NOTE: While the machine processes a job,
do not pull out the tray in use.
2. Remove the remaining paper.
3. Slide the paper guides towards the
front and back of the tray.
4. Slide the paper guide to the right.
5. Load a new stack of paper neatly and
tightly against the left corner of the tray,
with the side to be printed facing up.
NOTE: Do not load mixed types or mixed
sizes of paper together in Tray 2.
NOTE: Do not load paper above the
maximum fill line as it may cause a paper
jam or a machine malfunction.