Installation and Setup
50 Xerox
®
WorkCentre
®
6025 Multifunction Printer
User Guide
Setting the Fault Time-Out Timer
The fault timeout allows you to set how long the printer waits before canceling a print job that stops
abnormally.
To set the Fault Time-Out timer:
1. In the System Settings menu, navigate to Fault Time-Out, then press OK.
2. Select On, then press OK.
3. To enter a time in seconds, use the numeric keypad, then press OK.
Setting the Job Time-Out Timer
You can specify the amount of time the printer waits for data to arrive from a computer before
canceling the print job.
To set the Job Time-Out timer:
1. In the System Settings menu, navigate to Job Time-Out, then press OK.
2. Select On, then press OK.
3. To enter a time in seconds, use the numeric keypad, then press OK.
Setting the Clock
1. In the System Settings menu, navigate to Clock Settings, then press OK.
2. Next to Date Format, Time Format, and Time Zone, select the setting for each from the
corresponding list.
3. Using the selected format, next to Set Date, enter the date.
4. Using the selected format, next to Set Time, enter the time.
5. To exit the Clock Settings menu, press Back/Return.
Setting Alerts
You can set the printer to alert you when certain errors occur.
To set the alert options:
1. In the System Settings menu, navigate to Alert Tones, then press OK.
2. To set an alert, select an alert type, then press OK.
3. Select an alert tone volume, then press OK.
Setting the Units for Custom Paper Sizes
1. In the System Settings menu, navigate to mm/inch, then press OK.
2. Select Millimeters (mm) or Inches ("), then press OK.
To Next Page
Loading...
Need help?
General
