Copying
148 WorkCentre 7800 Series Multifunction Printer
System Administrator Guide
Specifying Output Settings
1. At the printer control panel, press the Machine Status button, then touch the Tools tab.
2. Touch Device Settings.
3. Touch Output.
4. Make the desired changes to the features:
− Contention Management prioritizes copy and print jobs.
• Priority specifies the relative priority of the copy or print jobs. The lower the number, the
higher the priority.
• First In/First Out schedules jobs to print based on their entry into the Job Queue.
− Out of Staples Options specifies how the printer handles a print job that requires staples when
the printer has run out of staples.
− Output Location specifies the location for jobs when a finisher is not available.
− Within Job Offsetting instructs the printer to separate print sets within an overall job. If you
select Disable, the printer stacks all printed sets together.
− Staple Productivity Mode specifies where the printer applies staples to a print job.
5. When finished, touch Save.
Note: Not all options listed are supported on all printers. Some options apply only to a specific
printer model, configuration, operating system, or driver type. Some options are available only if a
finisher is installed.
To Next Page
Loading...
Need help?
General
