Xerox WorkCentre 7220 System Administrator Guide

Network Connectivity
WorkCentre 7800 Series Multifunction Printer 33
System Administrator Guide
IP
Internet Protocol (IP) is a protocol within the Internet Protocol Suite that manages the transmission of
messages from computer to computer.
Enabling TCP/IP
1. At the printer control panel, press the Machine Status button, then touch the Tools tab.
2. Touch Network Settings > TCP/IP Settings.
3. Touch TCPIP Enablement.
4. Touch Enable for IPv4 or IPv6, then touch Close.
Note: By default, TCP/IP is enabled. If you disable TCP/IP, enable it at the printer control panel
before you access CentreWare Internet Services. For details, see IP on page 33 and HTTP on
page 55.
Configuring the Network Address Manually at the Control Panel
1. At the printer control panel, press the Machine Status button, then touch the Tools tab.
2. Touch Network Settings > TCP/IP Settings.
3. Touch Dynamic Addressing.
4. Touch Disabled, then touch OK.
5. Touch IPv4, then type the IPv4 address, gateway address, and network mask. After each address,
touch OK.
6. When finished, touch OK.

Xerox WorkCentre 7220 Specifications

General

Functions	Print, Copy, Scan, Fax
Print Technology	Laser
Color Output	Color
Copy Resolution	Up to 600 x 600 dpi
Scan Resolution	Up to 600 x 600 dpi
Fax Speed	33.6 Kbps
Standard Paper Capacity	1, 090 sheets
Duplex Printing	Yes
Memory	2 GB
Hard Drive	160 GB
ADF Capacity	50 sheets
Type	All-in-One
Print Speed	20 ppm
Copy Speed	20 cpm
Connectivity	USB 2.0, Ethernet
Network Connectivity	Ethernet
Operating System Compatibility	Windows, Mac, Linux