174
Enabling Ports and Setting TCP/IP
In order to use the job flow service, you must enable the SOAP port, the SNMP port, the Internet Service
(HTTP) port, and set IP addresses. The procedure for setting the machine is as follows.
Note: The configuration can also be performed using CentreWare Internet Services.
For information on how to use CentreWare Internet Services, refer to the Internet Services section of
this guide.
1. Display the System Administrator Menu screen.
a. Press the Log In/Out button.
b. Enter the user ID with the numeric keypad or a keyboard displayed by pressing Keyboard, and
select Confirm.
Note: The default user ID is “11111”. When using the Authentication feature, a password is required.
The default password is “x-admin”.
c. Select System Settings.
2. Enable the SOAP port.
a. Select System Settings.
b. Select Network Settings.
c. Select Port Settings.
d. Select SOAP and then select Change Settings.
e. Select Port Status and then select Change Settings.
f. Select Enabled then select Save.
g. Select Close until the Port Settings screen is displayed.
To Next Page
Loading...
Need help?
General
