204
Configuring Network authentication (by a remote Accounting server)
Network authentication uses the user information managed on a remote Accounting server to manage
authentication (access) to available machine services.
Enable Network Authentication
To enable Network Authentication for use with this Device, at your networked workstation, perform the
following steps:
1. Open your Web browser and enter the TCP/IP address of the machine in the Address or Location
field. Press Enter.
2. Click the Properties tab.
3. Select Auditron Administration in the list of hot links.
4. Select Network Access from the Auditron Mode drop-down list.
5. Place a checkmark in the Enable box for each service that you wish to restrict access to. For
explanations of each service, click the Help button.
6. From the Check User Details drop-down menu, select either On or Off (keep logon records). The
On selection will verify user information. When Off (keep logon records) is selected, User ID and
Account ID must be entered at the Device, but user information will not be checked. A logon record
will be kept by the Device, however.
7. Click Apply and enter the Administrator User name and password when prompted.
8. Click the Reboot Machine button, then OK, when prompted.
9. Refresh your web browser, then click on the User Details Setup link to set the Store User Details
setting. Note that you can set either NVM or hard disk as the destination for saved authentication
information. User Details Setup also allows you to configure the characteristics of the login prompt
for User Authentication.
To Next Page
Loading...
Need help?
General
