41
Microsoft (NetBIOS over IP) Networks B6
Before You Start
1. Print a Settings List as stated in the Network Connectivity section of this guide.
2. Referring to the Settings List, verify that SMB is enabled. To enable SMB at the Device, if required,
follow the procedure below.
3. Referring to the Settings List, verify that DNS (or WINS, if using only a Windows NT network) is
enabled. The use of Naming Servers is REQUIRED to resolve NetBIOS device names to IP
addresses for packet routing over the TCP/IP network.
4. To enable the Device to communicate with the Naming Servers, refer to the instructions supplied in
the topic "TCP/IP Dynamic Addressing", located in the NOS Selection section of this guide.
5. When using WINS or DNS, be sure to refer to your Server Operating System documentation for the
appropriate procedure to use to enable NetBIOS name to IP address resolution on the Server.
Enabling the SMB Setting at the Device, if required
1. Press the Log In / Out button on the Control Panel.
2. Press the "1" key on the numeric keypad five consecutive times. (This is the factory default
"password.")
3. Press the rectangular Confirm button on the touch screen.
4. Press the System Settings button (the right-hand button of the two buttons displayed on the touch
screen). Note: If you press the left button by mistake, the Main menu will be displayed and you will
have to start over at step one above.
5. Press the System Settings button.
6. Press the Network Settings button.
To Next Page
Loading...
Need help?
General
