263
Restricting Device Access N.5.8.2
Using Internet Services, access to the Device's Services can be restricted by Host IP Address.
To restrict device access, perform the following steps:
1. Open your Web browser and enter the TCP/IP address of the Device in the Address or Location field.
Press Enter.
2. Click the Properties tab.
3. Click the plus symbol (+) to the left of the Protocol Settings file folder.
4. Select TCP/IP in the directory tree
5. Scroll down the page to reveal the IP Address List subject label.
6. Enable (with a check mark) the IP Filter check box.
7. Click the available Edit button.
8. When the list of ten lines of IP Address and Subnet Mask entry boxes is displayed, supply the IP
Addresses and Subnet Masks of up to ten hosts (individual workstations) that are authorized to
access the Device's services. Caution: All other hosts, not specified in this list, will be prevented
from accessing the Device's services.
9. Click the Apply button to accept the changes. To exit the settings screen without making changes,
click the Undo button.
Note: Changes to settings are not applied until you restart the Device. A Reboot Machine button is
available on the Status Tab of Internet Services.
To Next Page
Loading...
Need help?
General
