253
6. Either accept the default Host (Print Server) Name or type in a new name that matches the name
used on the Server.
7. Select the type of NetWare network (Mode) that applies to your situation.
8. If setting up this printer in a Bindery environment, provide the name of the Primary Server.
9. Enter in a polling rate for Polling Interval (Queue Polling Interval).
10. Enter in a SAP (service advertising protocol) frequency, or set Number of Searches (SAP frequency)
to zero (off).
11. Type a Password for the Device to log into the NetWare Server, and type it a second time for
confirmation.
12. For NetWare NDS (NetWare Directory Services), type a directory tree name and context (typeful
name in the NDS environment). Note: Since there is no Browse function, you MUST manually enter
in this information. For example: O=xerox.OU=engineering.
13. For Frame Selection, if in doubt, leave the setting at its Auto (auto sensing) default value.
14. Click the Apply button, then click the Reboot button to reboot the Device and apply setting changes.
Note: A Reboot Machine button is always available on the Status Tab of Internet Services.
To Next Page
Loading...
Need help?
General
