274
4. If the Printer's (SMB Host) name appears twice in Network Neighborhood ("My Network Places" in
Windows Me), you need to use Internet Services to change the Printer's (SMB Host) name. To
change this name you have to be running the TCP/IP protocol on at least one workstation on your
network and have the TCP/IP protocol enabled and a static IP address set at both the workstation
and the Device. Verify that Internet Services is enabled at the Device. If it isn't, follow the
instructions supplied in the Network Connectivity section of this guide to enable Internet Services.
Change the Printer's (SMB Host) name following the instructions supplied in the Configure SMB
procedure in the Internet Services section of this guide.
5. To assure successful printing, make sure that the Device is configured to support the Page
Description Language (PDL) being used by your driver. To check the PDL being used by the driver,
print a test job "to file." Open and view the job in a program such as Notepad. The PDL being used
by the driver will be displayed in the first few lines of Printer Language. Next, check the Page
Description Languages being supported by the Device's ports by following the instructions supplied
under the Setting PDL Emulations procedure in the Internet Services section of this guide. The
PDL being used by the driver, and the PDL supported by the Port you are printing to, MUST match for
successful printing to occur.
To Next Page
Loading...
Need help?
General
