FusionServer 2288H V6 Server
Technical White Paper
Table 5-43 NVMe drive indicators (VMD disabled)
Activity Indicator
(Green)
The NVMe drive is not detected.
The NVMe drive is detected and operating
properly.
Data is being read from or written to the
NVMe drive.
The NVMe drive is being located or
hot-swapped.
The NVMe drive has completed the hot
swap process and is removable.
The NVMe drive is faulty.
M.2 FRU Indicators
The server supports the Avago SAS3004iMR RAID controller card, which supports two M.2
FRUs.
Figure 5-72 M.2 FRU indicators
Table 5-44 M.2 FRU indicators
M.2 FRU Active
Indicator (Green)
M.2 FRU Fault
Indicator (Yellow)
The M.2 FRU is not detected.
The M.2 FRU is in the read/write or
synchronization state.
The M.2 FRU is being located.
The RAID array is being rebuilt.
The M.2 FRU cannot be detected or
To Next Page
Loading...
