Xilinx VCU118 - Page 140

VCU118 Board User Guide 140
UG1224 (v1.0) December 15, 2016
www.xilinx.com
Appendix B: Master Constraints File Listing
set_property IOSTANDARD SSTL12 [get_ports "RLD3_C3_72B_CK_P"];
set_property PACKAGE_PIN H30 [get_ports "RLD3_C3_72B_CK_N"];
set_property IOSTANDARD SSTL12 [get_ports "RLD3_C3_72B_CK_N"];
set_property PACKAGE_PIN K29 [get_ports "RLD3_C3_72B_WE_B"];
set_property IOSTANDARD SSTL12 [get_ports "RLD3_C3_72B_WE_B"];
set_property PACKAGE_PIN L30 [get_ports "RLD3_C3_72B_REF_B"];
set_property IOSTANDARD SSTL12 [get_ports "RLD3_C3_72B_REF_B"];
set_property PACKAGE_PIN N29 [get_ports "RLD3_C3_72B_CS_B"];
set_property IOSTANDARD SSTL12 [get_ports "RLD3_C3_72B_CS_B"];
set_property PACKAGE_PIN L29 [get_ports "RLD3_C3_72B_RESET_B"];
set_property IOSTANDARD SSTL12 [get_ports "RLD3_C3_72B_RESET_B"];
# BPI FLASH
# BPI_FLASH_D[3:0] are wired to FPGA U1 Bank 0
# CONFIGURATION BITS D[3:0} ARE NOT USER ACCESSIBLE
# PACKAGE_PIN AP11 - BPI_FLASH_D0 Bank 0 - D00_MOSI_0
# PACKAGE_PIN AN11 - BPI_FLASH_D1 Bank 0 - D01_DIN_0
# PACKAGE_PIN AM11 - BPI_FLASH_D2 Bank 0 - D02_0
# PACKAGE_PIN AL11 - BPI_FLASH_D3 Bank 0 - D03_0
# PACKAGE_PIN AJ11 - BPI_FLASH_CE_B Bank 0 - RDWR_FCS_B_0
set_property PACKAGE_PIN AM19 [get_ports "BPI_FLASH_D4"];
set_property IOSTANDARD LVCMOS18 [get_ports "BPI_FLASH_D4"];
set_property PACKAGE_PIN AM18 [get_ports "BPI_FLASH_D5"];
set_property IOSTANDARD LVCMOS18 [get_ports "BPI_FLASH_D5"];
set_property PACKAGE_PIN AN20 [get_ports "BPI_FLASH_D6"];
set_property IOSTANDARD LVCMOS18 [get_ports "BPI_FLASH_D6"];
set_property PACKAGE_PIN AP20 [get_ports "BPI_FLASH_D7"];
set_property IOSTANDARD LVCMOS18 [get_ports "BPI_FLASH_D7"];
set_property PACKAGE_PIN AN19 [get_ports "BPI_FLASH_D8"];
set_property IOSTANDARD LVCMOS18 [get_ports "BPI_FLASH_D8"];
set_property PACKAGE_PIN AN18 [get_ports "BPI_FLASH_D9"];
set_property IOSTANDARD LVCMOS18 [get_ports "BPI_FLASH_D9"];
set_property PACKAGE_PIN AR18 [get_ports "BPI_FLASH_D10"];
set_property IOSTANDARD LVCMOS18 [get_ports "BPI_FLASH_D10"];
set_property PACKAGE_PIN AR17 [get_ports "BPI_FLASH_D11"];
set_property IOSTANDARD LVCMOS18 [get_ports "BPI_FLASH_D11"];
set_property PACKAGE_PIN AT20 [get_ports "BPI_FLASH_D12"];
Send Feedback