Xilinx Zynq UltraScale+ ZCU208 - Page 8

○ ADC_CLK_225 (direct connect SMAs)
○ DAC_CLK_230 (direct connect SMAs)
○ USER_MGT_SMA_CLK (series capacitor connected SMAs)
• PS DDR4 4 GB 64-bit SODIMM
• PL DDR4 C0 I/F 2 GB 32-bit component (4x8-bit)
• PS GTR (bank 505) assignment
○ USB3 (1 GTR)
○ SATA with M2 connector (1 GTR)
○ 2 GTRs not used
• PL GTY assignment (4 quads, 16 total GTY)
○ zSFP+ (4 GTY, 2 on quad GTY128 and 2 on quad GTY129)
○ 8A34001 (1 GTY, quad GTY128)
○ Carlisle CoreHC2 J128 (1 GTY, quad GTY129)
○ FMCP HSCP DP (4 GTY, bank GTY130)
○ FMCP HSCP DP (4 GTY, bank GTY131)
○ 1 GTY not used (quad GTY128)
○ 1 GTY not used (quad GTY129)
• PL FMCP HSCP (FMC+) connecvity - full LA[00:33] bus
• PS MIO connecvity
○ PS MIO[0:5, 7:12]: dual QSPI
○ PS MIO[13]: PS_GPIO2
○ PS MIO[14:17]: 2 channels of I2C
○ PS MIO[18:19]: UART0 (1 of 3 FT4232 UART channels)
○ PS MIO[22:23]: PS_PB, PS_LED I/F
○ PS MIO[26]: PMU
○ PS MIO[32:37]: PMU_GPO[0:5]
○ PS MIO[38]: PS_GPIO1
○ PS MIO[40:42, 45:51]: SD I/F
○ PS MIO[52:63]: USB3.0
Chapter 1: Introduction
UG1410 (v1.0) July 8, 2020 www.xilinx.com
ZCU208 Board User Guide 8
Send Feedback