Xplore iX104C3 - Sample 2

Appendix F. Configuring Dual Mode Tablet Digitizer Input Methods
Sample implementations
104 iX104C
3
User’s Handbook
Sample 2
To set the tablet to the following configuration:
■ Default digitizer input control is Auto Sense.
■ The user can temporarily change the digitizer input control
settings.
■ The user can change the default digitizer input control settings.
Configure settings as follows:
1. Do not use the BIOS Setup Utility to set a Supervisor password.
2. Use the Panel Control Center to set one of the P keys to Digitizer
Selection.
3. Use the Add new user function to create a user account.
Note: If the user already exists, the setting the administrator has
set replicates to all the users of the computer.