Xtrails ADPRO iFT - Chapter 3: Second Hard Disk Installation; Installing a Second Hard Disk

iFT Series Hardware Installation Manual ADPRO
16 27817_05
8. Connectamonitor/screenandkeyboardtothedevice.Switchonthepowersupplyandwaitfortheboot
windowtoappear.
9. SelectXO Installer andpressEnter.
Note
Thebootwindowonlyappearsforafewseconds,thenthedevicecontinuesbooting.Tomake
surethatyoudonotmissit,pressthearrowkeysonthekeyboardrepeatedlywhilethedeviceis
booting.Thedevicewillthenstopatthebootwindow,andthisgivesyoutimetoselectandopen
theXO Installer menu.
10. ChooseUpdate current system >Manage recording disks.
11. SelectthenewlyinstalledharddiskinthelistandpressEnter.
12. ChooseFormat and use selected disks (usingthetabkey).Thesystemformatstheselectedharddisk.
13. Whenformattingisfinished,chooseMain Menu,andthenchooseReboot.
Thedevicenowrestarts.Afterrestarting,theinstalledharddiskisreadyforuse.
3.6 Installing a Second Hard Disk
Materialrequiredforthesecondharddisk:
Part Amount + reference number
Diskscrews 8x#17434080
SATAcable 1x#16520877
iFT(-E)HDDbracket 1x#17011890
iFT(-E)HDDbracket,L-shaped
1
1x#17011895
Caution!
l Beforeinstallingharddisks,stopthedevice.Switchitoffandunplugthepowercord.
l Takeallnecessaryprecautionstopreventstaticdischargesthatmaydamagethedevice:usean
anti-staticwristband,ananti-staticmat…
l Theprocedurebelowassumesthatyouareusinganew disk,or,incaseofauseddisk,thatyou
willformat the used disk anderaseallrecordingsonit.Ifyouwanttoinstallausedharddisk
whilekeepingtherecordingsonit,followtheinstructionsintheTechTipRecovering Recordings
from Used HDDs(29160).
Toinstallasecondharddisk,proceedasfollows:
1. Stopthedevice,switchoffthepowersupply,andthenremovethetopcover:unscrew2screwsatthefront,
4atthetop,and3attheback.

2. Ifthefirstdiskisalreadyinstalled,youhavetoremoveitfirst:unplugitspoweranddatacables,and
unscrewitfromthebottomofthecasing.
1
TheL-shapedbracketisrequiredifyouinstallmorethan2disks.Ifyouwilluseonly2disks,youcanuse2‘flat’HDD
brackets(#17011890).