Xylem YSI 2500 - Page 44

To Next Page

To Previous Page

6-21

To align the sipper at other locations, touch the button under Location.

Touch the button for your location, [Station 2] for example.

Touch the [Position] button and use the arrow buttons to align the sipper with the selected location.

Location

Main Page

Table of Contents2
Introduction5
Description5
General Specifications5
Safety6
Important Safety Instructions6
Explanation of Symbols7
Getting Started8
Unpacking8
Warranty Card9
What You Need9
Major Components9
Basic Setup12
Install Bottle Rack12
Connect Printer13
Connect AC Power13
Align Sipper15
Prepare and Install Buffer Solution18
Prepare Buffer18
Install Buffer Solution18
Install Calibrator Solution18
Prime the Fluid System19
Install Enzyme Membranes19
Configure Instrument21
Assign Chemistries to Probes21
Buffer22
Calibrator22
Check Probe Currents23
Running the Instrument24
Perform Daily Operational Checks24
Enzyme Membrane Integrity Test24
Linearity Test26
Results27
Sample Preparation28
Run Batch28
Create Batches28
Export30
Load Samples30
Run Samples31
Status31
Run Stat32
Advanced Functions35
Settings35
System35
Display38
Date/Time42
Service43
Sipper43
Module46
Data50
Plate50
Calibration53
Help53
About53
Software54
Connectivity56
Ethernet Port56
RS232 Port58
Chemistry Setup59
Sample Volume59
Measurement Parameter Information59
D-Glucose (Dextrose)60
L-Lactate61
Simultaneous Glucose and L-Lactate62
Operational Checks and Maintenance63
Cleaning, Disinfecting, and Decontaminating63
Touch Panel63
Decontamination Procedures63
Daily Maintenance63
Empty the Waste Bottle63
Check the Calibrator Bottle63
Check the Buffer Bottle64
Check for Leaks64
Clean up Spills64
Daily Operational Checks64
Monthly Maintenance64
Calibration Pumping System Maintenance64
Buffer Pumping System Maintenance64
Bottle Cap Cleaning65
Sample Module Cleaning65
Preventive Maintenance - 6 Months or 1000 Hours65
Waste Module Cleaning66
Enzyme Probe Cleaning66
Sipper Pump Seal Replacement67
Bottle Tubing68
Pump Tubing Replacement69
Install Waste Module71
Waste Tubing71
Install Sample Module71
Sipper Replacement71
Calibrate Sipper73
Install Bottles73
Install Membranes73
Prime Fluid System73
Fuse Replacement73
Fuse Requirements73
Storage74
Instrument Storage74
Enzyme Membrane Storage74
Instrument Handling/Transport74
Troubleshooting75
Printout Information76
Troubleshooting Chart78
Principles of Operation83
Enzyme Sensor Technology83
Measurement Methodology84
Baseline Stability84
Calibration84
Linearity85
Temperature Compensation85
Level Sensing85
Warranty and Repair86
Limitation of Warranty86
Shipping Instructions86
Cleaning Instructions87
YSI Factory Authorized Service Centers87
Notices88
Declaration of Conformity88
Radio and Television Interference Notice89
Appendix A - Software Flowchart90
Appendix B - Concentration Unit Conversion91
Linearity Test. Concentration Unit Conversion91
FCN Membrane Integrity Test. Concentration Unit Conversion91
Appendix C - Effects of Selected Substances92
Appendix D - Line Power Cord and Plug Wiring96
Appendix E - Reagents and Accessories97

Xylem YSI 2500 - Page 44

Table of Contents

Related product manuals