Yaesu FTA-310 - Page 62

FTA-310 OperATing MAnuAl
60
Fly to a VOR station 1. Select a VOR station on your
aeronautical chart and turn the DIAL selector knob (or enter the frequency directly with the keypad) to the frequency of the VOR station.
2. Select the “TO” flag when flying
to the VOR station or select the “FROM” flag when flying away from the VOR station.
3. Press
[
F
]
key, then press
[
4/CDI
]
key to select CDI mode.
The couse indicator shows “OFF”
when the VOR signal can not received.
4. Press and hold in the
[
( )]
key
for 2 seconds to change the “COURSE INDICATOR” display size.
Field Programming Mode 1. Press and hold in both the PTT
switch and VOLUME knob, while turning the radio on.
2. Select the desired frequency to
be stored in the Book Memory.
3. P r e s s a n d h o l d i n t h e
[
MW
(
SPL-W
)]
key for 2 seconds.
4. Rotate the DIAL selector knob
to select the desired memory channel number for storage.
5. P r e s s a n d h o l d i n t h e
[
MW
(
SPL-W
)]
key for 2 seconds.
To attach an alpha/numeric name
(label) to the memory, proceed to the next step; otherwise press and hold in the
[
MW
(
SPL-W
)]
key
for 2 seconds to save the entry and exit.
6. To label a memory with an alpha/
numeric name, the next step is to use the DIAL selector knob to select any of the 48 available characters.
7. P r e s s t h e V O L U M E k n o b
momentarily to select it and move on to the next character.
8. After entering the entire name
(eight characters maximum), press the
[
MW
(
SPL-W
)]
key for 2
seconds to save all data for the channel.
9. Turn the radio off, then turn the
radio back on again to begin normal operation.