4. Remove steering column covers. Remove floor
mats and floor plate. See section Hood, Seat, and
Side Covers Replacement.
NOTE: Perform Step 5 for lift trucks equipped with bi-
fuel or LPG engines.
5. Remove four capscrews, four bushings and steer-
ing column from cowl standoffs. See Figure 14.
NOTE: Perform Step 6 for lift trucks equipped with
diesel engines.
6. Remove four capscrews, four bushings, four iso-
lators, steering column and four isolators from
cowl standoffs. See Figure 14.
Disassemble
NOTE: Remove and discard snap rings if installed.
1. Remove two pins and gas spring from housing.
See Figure 15.
2. Remove two pivot bolts, two bushings, two nuts
and bracket from housing.
3. Remove split pin and lower shaft from upper
shaft.
4. Remove connector from connector bracket. Re-
move connector bracket, fastener, four screws
and two horn contacts from housing.
NOTE: DIESEL SHOWN, LPG AND GAS SIMILAR.
1. CAPSCREW
2. BUSHING
3. ISOLATOR
4. STEERING COLUMN
5. COWL STANDOFF
Figure 14. Steering Column Remove/Install
0100 YRM 1766 Steering Column
13
To Next Page
Loading...