14. Remove two capscrews and washers from cover
plate and remove electrical cover. Disconnect
seat harness from chassis harness. See Figure 7.
CAUTION
When removing the seat from the hood, do not
use an impact wrench to remove the capscrews.
Damage can be caused to the threads on the cap-
screws and in the holes.
15. Open hood and pull chassis harness through hole
in hood. See Figure 8.
Remove the four capscrews and nuts holding the
seat to the hood. Lift the seat off the hood. See
Figure 8. Close hood.
16. Remove the nuts from ball studs on gas springs.
Remove gas springs from the hood. See Figure 9.
17. Remove the hinge capscrews and nuts, located in
the rear of the hood. See Figure 9.
18. Lift the hood from the truck.
A. NON-SUSPENSION SEAT B. FULL SUSPENSION SEAT
1. CAPSCREWS
2. WASHER
3. COVER PLATE
4. ELECTRICAL CONNECTOR (SEAT HARNESS)
5. ELECTRICAL COVER
Figure 7. Disconnect Seat Wire Harness
Hood, Seat, and Side Covers Replacement 0100 YRM 1766
8
To Next Page
Loading...