Top Panel Controls 19
01V—Owner’s Manual
put. Normally, [ON] buttons 1 through 8 select channels 1 through 8. When the
[OPTION I/O] button is pressed, however, they select input channels 17 through 24,
which are only available when an Option I/O card is installed. See “ON Buttons” on
page 34 for more information.
The [ON] buttons 1 through 16 and master can be assigned to various internal param-
eters on REMOTE page 1, or used as MIDI controllers on REMOTE page 3. See
“Assigning Faders & On Buttons” on page 194 and “User Defined MIDI Controllers”
on page 238 for more information.
D Faders
Depending on the selected fader mode, the 01V’s 60 mm motorized faders are used to
control channel levels, aux send levels, or effects sends levels. Normally, faders 1
through 8 control channels 1 through 8. When the [OPTION I/O] button is pressed,
however, they control input channels 17 through 24, which are only available when an
Option I/O card is installed. See “Faders (plus Return Rotary Controls)” on page 35 for
more information.
Faders 1 through 16 and master can be assigned to various internal parameters on
REMOTE page 1, or used as MIDI controllers on REMOTE page 3. See “Assigning Fad-
ers & On Buttons” on page 194 and “User Defined MIDI Controllers” on page 238 for
more information.
E RETURN Controls
The RETURN controls are used to adjust the effects return levels, and their positions
are displayed in the lower-left corner of the display.
F SOLO Status Indicator
The SOLO status indicator lights up when a channel is soloed.
To Next Page
Loading...
