Yamaha DSP5D - Page 304

PAN/ROUTING function
304 PM5D/PM5D-RH V2 / DSP5D Owner’s Manual Reference section
ALL OFF [ALL CH ]
ALL ON [ALL CH ]
Switch the signals sent from all input channels to the
selected MIX bus on or off together.
ALL OFF [ALL CH x ALL MIX]
ALL ON [ALL CH x ALL MIX]
Switch the signals sent from all input channels to all
MIX buses on or off together.
• Mix send position
Move the cursor to a PRE/POST button in the CH to
COPY area; then hold down the [SHIFT] key and click
(or press the [SHIFT] key + [ENTER] key) to access
the following window.
To set multiple parameters at once, use the [DATA]
encoder to select one of the following items, and click
the OK button.
ALL POST [ALL MIX ]
ALL PRE [ALL MIX ]
Switch the send position of the signal sent from the
selected input channel to all MIX buses to either post-
fader or pre-fader.
ALL POST [ALL CH ]
ALL PRE [ALL CH ]
Switch the send position of the signal sent from all
input channels to the selected MIX bus to either post-
fader or pre-fader.
ALL POST [ALL CH x ALL MIX]
ALL PRE [ALL CH x ALL MIX]
Switch the send position of the signal sent from all
input channels to all MIX buses to either post-fader
or pre-fader.
Note
These “all-at-once” operations are ignored by FIXED-type MIX
buses.
• Mix send level
Move the cursor to a SEND LEVEL knob in the CH to
COPY area; then hold down the [SHIFT] key and click
(or press the [SHIFT] key + [ENTER] key) to access
the following window.
To set multiple parameters at once, use the [DATA]
encoder to select one of the following items, and click
the OK button.
LEVEL COPY [ALL MIX ]
The value of the selected SEND LEVEL knob will be
copied to the send level of the signals sent from that
input channel to all MIX buses.
LEVEL COPY [ALL MIX ]
The value of the selected SEND LEVEL knob will be
copied to the send level of the signals sent from all
input channels to that MIX bus.
LEVEL COPY [ALL CH x ALL MIX]
The value of the selected SEND LEVEL knob will be
copied to the send level of the signals sent from all
input channels to all MIX buses.
Note
These “all-at-once” operations are ignored by FIXED-type MIX
buses.