Yamaha DTX900 - Loading a Specific Trigger Setup From an “All Data” or “All Trigger” File; Loading a Specific Chain From an “All Data” or “All Chain” File

File Mode [FILE]
Reference
118
DTX900 Owner’s Manual
You can also load a single, specific Trigger Setup from the
file (File extension: .T3A or .T3T) to the desired Trigger
Setup number.
1
Press the [FILE] button to enter the File
mode, then press the [F2] LOAD button to
call up the Load display.
2
Move the cursor to TYPE, then set the File
type to “Trigger.”
Only available files according to the Type are listed in the
Directory/File list box on the display.
3
Move the cursor to the Directory/File list
box, then select the file to be loaded.
You can select any of the files listed in the Directory/File list
box on the display.
4
Press the [ENTER/STORE] button so that
the Trigger Setups included in the selected
file are shown in the Directory/File list box.
5
Move the cursor to the desired Trigger
Setup as Load source then press the [SF1]
EXEC button.
The Trigger Setup number and name for the Load destination
appear on the left half of the display.
6
Select the Trigger Setup number for the
Load destination.
7
Press the [SF1] EXEC button again to exe-
cute the Load operation.
You can also load a single, specific Chain from the file (File
extension: .T3A or .T3H) to the desired Chain number.
1
Press the [FILE] button to enter the File
mode, then press the [F2] LOAD button to
call up the Load display.
2
Move the cursor to TYPE, then set the File
type to “Chain.”
Only available files according to the Type are listed in the
Directory/File list box on the display.
3
Move the cursor to the Directory/File list
box, then select the file to be loaded.
You can select any of the files listed in the Directory/File list
box on the display.
4
Press the [ENTER/STORE] button so that
the Chains included in the selected file are
shown in the Directory/File list box.
5
Move the cursor to the desired Chain as
Load source then press the [SF1] EXEC
button.
The Chain number and name for the Load destination appear
on the left half of the display.
6
Select the Chain number for the Load des-
tination.
7
Press the [SF1] EXEC button again to exe-
cute the Load operation.
Loading a Specific Trigger Setup From
an “All Data” or “All Trigger” File
Loading a Specific Chain From an
“All Data” or “All Chain” File