Yamaha MX800V - Checking the Switch Continuity; Checking the Oil Pressure Switch; Checking the Tci Unit Resistance; Notice

5-5
1
2
3
4
5
6
7
8
9
10
ELECTRICAL
ELECTRICAL COMPONENTS
CHECKING THE SWITCH CONTINUITY
Check each switch for continuity with the tester. If the con-
tinuity reading is incorrect, check the wiring connections
and if necessary, replace the switch.
TIP
• Before checking for continuity, set the digital circuit tester
to the “” range.
• When checking for continuity, switch back and forth
between the switch positions a few times.
CHECKING THE OIL PRESSURE SWITCH
1. Drain:
• Engine oil
2. Disconnect:
• Oil pressure switch lead
3. Connect:
• Digital circuit tester
(between the engine ground and oil pressure switch
terminal)
4. Check:
• Oil pressure switch continuity
No continuity  Replace the oil pressure switch.
CHECKING THE TCI UNIT RESISTANCE
The following procedure applies to all of the TCI units.
1. Check:
• Coil resistance
Out of specification  Replace.
Ω”
”
O.L”
”
Never insert the tester probes into the coupler termi-
nal slots. Always insert the probes from the opposite
end of the coupler, taking care not to loosen or dam-
age the leads.
Model 88 Multimeter with tachometer:
YU-A1927
NOTICE
Model 88 Multimeter with tachometer:
YU-A1927