7-25
1
2
3
4
5
6
7
8
9
10
SPECIFICATIONS
WIRE ROUTING DIAGRAM
1. Air filter case cover 1 4. Joint 2
2. Air filter case stay 5. Air filter case
3. Breather hose
A. Install the air filter case stay into the groove in the air filter case.
B. Insert the hose until it reaches the end as shown in the illustration.
C. Install the screw in the direction shown in the illustration.
D. Insert the air filter cover 1 until it contacts the air filter case.
E. Installation angle of joint 2 15.75 (reference value)
F. Install the joint 2 in the direction shown in the illustration.
G. Insert from 22 mm (0.87 in) until contact is made as shown in the illustration.
H. The air filter case and joint 2 should not be bent or detached due to unreasonable installation.
I. Install the air filter case in the direction shown in the illustration.
J. 5–7 mm (0.20–0.28 in)
To Next Page
Loading...
