4
4-8
Instrument and control functions
1. V-belt replacement indicator “V-BELT”
2. V-belt replacement tripmeter
1. Engine trouble warning light “ ”
2. Error code display
The oil change indicator “OIL” will flash
at the initial 1000 km (600 mi), then at
4000 km (2500 mi) and every 4000
km(2500 mi) thereafter to indicate that
the engine oil should be changed.
After changing the engine oil, reset the
oil change tripmeter and the oil change
indicator. To reset them both, select
the oil change tripmeter, and then push
the “RESET” button for one second.
Then, while “OIL” and the oil change
tripmeter are flashing, push the
“RE-SET” button for three seconds.
The oil change indicator will be reset.
If the engine oil is changed before the
oil change indicator comes on (i.e.,
before the periodic oil change interval
has been reached), the oil change
tripmeter must be reset for the next
periodic oil change to be indicated at
the correct time.
V-belt replacement tripmeter mode
The V-belt replacement tripmeter
shows the distance traveled since it
was last reset (i.e., since the last V-belt
replacement).
The V-belt replacement indicator
“V-BELT” will flash at every 25000
km(15500 mi) thereafter to indicate
that the V-belt should be replaced.
After replacing the V-belt, reset the
V-belt replacement tripmeter and the
V-belt replacement indicator. To reset
them both, select the V-belt replace-
ment tripmeter, and then push the
“RESET” button for one second. Then,
while “V-BELT” and the V-belt replace-
ment tripmeter are flashing, push the
“RESET” button for three seconds.
The V-belt replacement indicator will
be reset.
If the V-belt is replaced before the
V-belt replacement indicator comes on
(i.e., before the periodic V-belt
replacement interval has been
reached), the V-belt replacement
tripmeter must be reset for the next
periodic V-belt replacement to be
indicated at the correct time.
Self-diagnosis mode
This model is equipped with a
self-diagnosis device for various
electrical circuits.
To Next Page
Loading...
