5 - 25
CHAS
FRONT BRAKE AND REAR BRAKE
2. Air bleed:
• Brake system
Refer to “BRAKE SYSTEM AIR BLEED-
ING” section in the CHAPTER 3.
3. Inspect:
• Brake fluid level
Fluid at lower level → Fill up.
Refer to “BRAKE FLUID LEVEL INSPEC-
TION” section in the CHAPTER 3.
4. Install:
[Front]
• Reservoir float
• Diaphragm
• Master cylinder cap 1
• Screw (master cylinder cap) 2
[Rear]
• Diaphragm
• Master cylinder cap 1
• Bolt (master cylinder cap) 2
CAUTION:
After installation, while pulling the lever in
or pushing down on the pedal, check
whether there is any brake fluid leaking
where the union bolts are installed respec-
tively at the master cylinder and caliper.
È
Front
É
Rear
5. Install: (rear brake only)
• Protector 1
• Bolt (protector) 2
È
T
R
.
.
2 Nm (0.2 m · kg, 1.4 ft · lb)
T
R
.
.
2 Nm (0.2 m · kg, 1.4 ft · lb)
É
T
R
.
.
7 Nm (0.7 m · kg, 5.1 ft · lb)
To Next Page
Loading...
