(5) Reinstall the fuel injection pump drive gear
lock washer (Figure 15, (2)) and nut (Figure
15, (1)). Do not lubricate the threads of the
nuts or shaft. Hold the crankshaft pulley bolt
with a socket wrench and tighten the drive
gear nut to the specified torque.
Note:
Ensure the tapered surface of the fuel injection
pump shaft is clean and dry.
(6) Align the key on the fuel injection pump
shaft with the keyway in the fuel injection
pump drive gear hub. Reinstall the fuel
injection pump into the fuel injection pump
drive gear and gear housing. Reinstall the
pump retaining nuts finger tight.
If reinstalling the original fuel injection pump:
Align the reference marks (Figure 16, (1))
previously made on both the fuel injection
pump mounting flange and gear case or front
plate.
Tighten the fuel injection pump retaining nuts
to specification.
To Next Page
Loading...
