(4) Raise the lift arms (A) and the stopper & slow
return valve section (B), and then separate
the hydraulic cylinder case.
WARNING
It should be done by at least 2 people because
hydraulic cylinder case is heavy.
IMPORTANT
Two positioning pins are used between the
transmission case and the hydraulic cylinder case.
When you push the lift arms (A) up from the bottom,
the pins will come off and the hydraulic cylinder
case can be separated easily.
(5) Keep the hydraulic cylinder case upright, as
shown in the photo, so that the mating
surface is not damaged.
IMPORTANT
Completely remove the packing located between
the transmission case and the hydraulic cylinder
case.
To Next Page
Loading...
