Yanmar EF-494T - Page 65

2 DISASSEMBLY OF COMPONENTS 2 DISASSEMBLY OF COMPONENTS
EF494T TM 06/2011 edition
57
(10) Remove the high-pressure pipe (A).
(11) Move the reverser lever to the neutral
position, and remove the reverser rod (A).
IMPORTANT
Before removing the reverser rod, be sure that the
reverser lever is in the neutral position.
(12) Remove the nut (B) and pull the reverser (C)
change arm out about 15 mm.
(13) Attach a support to the front and back at the
separation point.
Note:
When the front section is lifted, the preferred
position is shown in the photo.