WARNING
Do not perform work on the drive while wearing loose clothing, jewelry or without eye
protection.
Failure to comply could result in death or serious injury.
Remove all metal objects such as watches and rings, secure loose clothing, and wear eye
protection before beginning work on the drive.
Do not remove covers or touch circuit boards while the power is on.
Failure to comply could result in death or serious injury.
Fire Hazard
Tighten all terminal screws to the specified tightening torque.
Loose electrical connections could result in death
or serious injury by fire due to overheating
of electrical connections.
Do not use an improper voltage source.
Failure to comply could result in death or serious injury by fire.
Verify that the rated voltage of the drive matches the voltage of the incoming power supply
before applying power.
Do not use improper combustible materials.
Failure to comply could result in death or serious injury by fire.
Attach the drive to metal or other noncombustible material.
Install adequate branch circuit protection according to applicable local codes and this
manual.
Failure to comply could result in fire and damage to the drive or injury to personnel. The
device is suitable for use on a circuit capable of delivering not more than 31,000 RMS
symmetrical amperes, 240 Vac maximum (200 V class) and 480 Vac maximum (400 V
class) when protected by branch circuit protection devices specified in this manual.
C.1 Section Safety
YASKAWA ELECTRIC TOEP C710606 25D YASKAWA AC Drive J1000 Installation & Start-Up Manual
253
C
Standards Compliance
To Next Page
Loading...
Need help?
General
