2.1 Section Safety.................................................................. 30
2.2
Mechanical Installation .................................................... 33
Installation Environment .......................................................33
Installation Orientation and Spacing........................................34
Exterior and Mounting Dimensions .........................................36
3.
ELECTRICAL INSTALLATION
....................................
39
3.1
Section Safety.................................................................. 40
3.2
Standard Connection Diagram......................................... 43
3.3
Main Circuit Connection Diagram .................................... 46
Single-Phase 200 V Class Models BA0001 to BA0010 ...............46
Three-Phase 200 V Class Models 2A0001 to 2A0020
Three-Phase 400 V Class Models 4A0001 to 4A0011 ...............46
3.4 Terminal Block Configuration.......................................... 47
3.5 Protective Covers ............................................................ 48
IP20/Open-Chassis Cover Removal and Installation...................48
3.6 Main Circuit Wiring .......................................................... 50
Main Circuit Terminal Functions .............................................50
Wire Gauges and Tightening Torque.......................................50
Main Circuit Terminal Power Supply and Motor Wiring................54
3.7 Control Circuit Wiring...................................................... 57
Control Circuit Terminal Block Functions..................................58
Terminal Configuration.........................................................59
Wiring Procedure ................................................................61
3.8 I/O Connections ............................................................... 64
Sinking/Sourcing Mode Switch...............................................64
3.9 Main Frequency Reference .............................................. 67
DIP Switch S1 Analog Input Signal Selection............................67
3.10 Braking Resistor.............................................................. 69
Installation.........................................................................69
3.11 Interlocking with Connected Machinery .......................... 71
Drive Ready Signal .............................................................71
3.12 Wiring Checklist .............................................................. 72
Table of Contents
4
YASKAWA ELECTRIC TOEP C710606 25D YASKAWA AC Drive J1000 Installation & Start-Up Manual
To Next Page
Loading...
