EasyManua.ls Logo

YASKAWA L1000A - Page 156

YASKAWA L1000A
247 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7 Option Card Installation
154 YASKAWA ELECTRIC TOEP C710616 38H YASKAWA AC Drive-L1000A Quick Start Guide
Take the following steps to prevent erroneous operation caused by noise interference:
Use shielded wire for the PG encoder signal lines.
Limit the length of all motor output power cables to less than 100 m. Limit the length of open-collector output lines to
less than 50 m.
Use separate conduit or cable tray dividers to separate option control wiring, main circuit input power wiring, and
motor output power cables.
Interface Circuit
Complementary Output
Figure 82
Figure 90 Complementary Outputs for the Interface Circuit
Open-Collector Outputs
Figure 83
Figure 91 Open-Collector Outputs for the Interface Circuit
Terminal Functions
Table 46 Option Terminal Functions
Terminal
Block
Terminal Function Description
TB1
<1> A separate UL Listed class 2 power supply is necessary when the PG requires more than 200 mA to operate.
A+ A+ pulse signal input
Pulse signal inputs from the PG.
Signal inputs from complementary and open-collector
outputs
Signal level
H level: 8 to 12 V
L level: 2.0 V or less
A– A– pulse signal input
B+ B+ pulse signal input
B– B– pulse signal input
Z+ Z+ pulse signal input
Z– Z– pulse signal input
SD NC pin (open) For use when cables shields should not be grounded
FE Ground Used for grounding shielded lines
TB2
IP PG power supply
Output voltage: 12.0 V ± 5%
Max output current: 200 mA
<1>
IG PG power supply common
AO A pulse monitor signal Outputs the monitor signal for the A, B, and Z pulses
from the PG speed control card
For open collector outputs from the option
Max voltage: 24 V
Max current: 30 mA
BO B pulse monitor signal
ZO Z pulse monitor signal
IG Monitor signal common
PG-B3
PG Encoder
470 Ω
330 Ω
330 Ω
A-,B-,Z-
A+,B+,Z+
IG
AO,BO,ZO
0 V
A,B,Z
Vcc
IP
IG
0 V
12 V
Monitor Signals
PG
B3
470 Ω
330 Ω
330 Ω
A+,B+,Z+
IG
AO,BO,ZO
IP
IG
12 V
PG Encoder
A,B,Z
Vcc
0 V
A,B,Z
Monitor Signals
AO
IG IG
ZO
IG
BO
IGIP
A-A+ FESDZ-Z+B-B+
TB1
TB2
TOEP_C710616_38H_7_0.book 154 ージ 015年11月11日 水曜日 午後7時40

Table of Contents

Other manuals for YASKAWA L1000A

Related product manuals