YASKAWA L1000A - Page 157

7 Option Card Installation
YASKAWA ELECTRIC TOEP C710616 38H YASKAWA AC Drive-L1000A Quick Start Guide 155
Option Card Installation
7
Wire Gauges and Tightening Torques
Wire gauge and torque specifications are listed in Tabl e 47. For simpler and more reliable wiring, use crimp ferrules on
the wire ends. Refer to the option manuals for the wire size and torque specifications of other options.
Table 47 Wire Gauges and Tightening Torques
Crimp Terminals
Yaskawa recommends using CRIMPFOX 6 by Phoenix Contact or equivalent crimp terminals with the specifications
listed in Table 48 for wiring to ensure proper connections.
Note: Properly trim wire ends so loose wire ends do not extend from the crimp terminals.
Table 48 Crimp Terminal Sizes
PG Encoder Cables for PG-B3 Option
Yaskawa recommends using a LMA-B-S185Y (complementary output) for cables running between the PG-B3
Option and the PG as show in Figure 92.
For instructions on wiring the terminal block, refer to Tabl e 46.
Figure 84
Figure 92 Wiring PG Encoder Cable
Terminal Signal
Screw
Size
Tightening
Torque
Nm
(lb.in.)
Bare Cable Crimp Terminals
Wire Type
Applicable
Gauges
mm
2
Recomm.
Gauge
mm
2
Applicable
Gauges
mm
2
Recomm.
Gauge
mm
2
A+, A–, B+,
B–, Z+, Z–,
FE, IP, IG
M2
0.22 to 0.25
(1.95 to 2.21)
0.75
(18 AWG)
Stranded wire:
0.25 to 1.0
(24 to 17 AWG)
Solid wire:
0.25 to 1.5
(24 to 16 AWG)
0.5
(20 AWG)
0.25 to 0.5
(24 to 20 AWG)
Shielded
twisted pair,
etc.
AO, IG, BO,
IG, ZO, IG
Shielded
cable, etc.
–
Wire Gauge
mm
2
Phoenix Contact Model
L
mm (in)
d1
mm (in)
d2
mm (in)
0.25 (24 AWG)
AI 0.25 - 6YE
AI 0.25 - 6BU
10.5 (13/32) 0.8 (1/32) 2 (5/64)
0.34 (22 AWG) AI 0.34 - 6TQ 10.5 (13/32) 0.8 (1/32) 2 (5/64)
0.5 (20 AWG) AI 0.5 - 6WH 12 (15/32) 1.1 (3/64) 2.5 (3/32)
d1
d2
6 mm
(0.24 in.)
L
A+ A- B+ B- Z+ Z- SD FE
IP IG AO IG BO IG ZO IG
Ｌ
A
B
C
D
E
F
G
H
TA1
TB1 TB2
（
Pin
）
3456 E 12
PG encoder side
B3
TOEP_C710616_38H_7_0.book 155 ページ ２０１５年１１月１１日 水曜日 午後７時４０分