3.2 Rotary Motor Mounting
30
Before Mounting
The shaft end is treated with a rust-preventative agent. Before mounting the motor, wipe
off this rust-preventative agent with a cloth soaked in thinner.
When removing the rust-preventative agent, be sure that the thinner does not contact any
other parts of the servomotor.
■ Storage Temperature
Store the servomotor within the temperature range below when storing without electrical
feed.
-20 ~ +60°C Temperature Range
■ Mounting Location
The SGM□H servomotor is intended for use indoors. Use in an environment meeting the
following conditions.
• Indoors, in a location free from corrosive or explosive gas.
• A location with good ventilation, with little dust, grime, or steam
• A location with an ambient temperature between 0~40°C
• A location with a relative humidity of 20%~80%, no condensation
• A location easy to inspect and clean
Important
Rust-
preventative
A gent
To Next Page
Loading...
Need help?
General
