3-1
158813-1CD
HW1480080
MH80 Manipulator
3 Installation
3 Installation
• Install the safeguarding.
Failure to observe this warning may result in injury or damage.
• Install the manipulator in a location where the manipulator’s tool or
the workpiece held by the manipulator will not reach the wall,
safeguarding, or DX100 when the arm is fully extended.
Failure to observe this warning may result in injury or damage.
• Do not start the manipulator or even turn ON the power before it is
firmly anchored.
The manipulator may overturn and cause injury or damage.
• Do not install or operate a manipulator that is damaged or lacks
parts.
Failure to observe this caution may cause injury or damage.
• Before turning ON the power, check to be sure that the shipping
bolts and brackets explained in section 2.2 “Shipping Bolts and
Brackets” on page 2-4 are removed.
Failure to observe this caution may result in damage to the driving
parts.
To Next Page
Loading...
