9 Maintenance and Inspection
9.3 Notes on Grease Replenishment/Exchange Procedures
9-10
158813-1CD
HW1480080
MH80 Manipulator
6. Wipe the discharged grease with a cloth and reinstall the plug PT1/8
on the grease exhaust port. Apply Three Bond 1206C to the thread
part of the plug, and tighten the plug with a tightening torque of 4.9
N·m (0.5 kgf·m).
7. Remove the grease zerk from the grease inlet and reinstall the plug
PT
1/4.
If the plug is installed while the grease is being exhausted,
the grease will go inside the motor and may cause a
damage. Ensure that the grease has been completely
exhausted before installing the plug.
To Next Page
Loading...
