10 Installation and basic configuration
2 Installation and basic configuration
2.1 Components
MotoAdmin package contains:
► 1 CD-ROM
► 1 Hardware key
► 1 RS232 cable; robot controller (9pin) <-> pc (9pin)
► 1 user manual
2.2 System requirements
► inW dows PC
• WindowsXP/2000/7
al COM interface • Ethernet TCP/IP network interface or seri
harddisk storage capacity • 20 MByte free
• CDROM drive
► Robot controller XRC, NX100 or DX100
oftware installation. Otherwise there may
e some problems in case of USB hardware keys.
software installation procedure, login to windows system with local adminis-
ative rights.
If
irectly
om CDROM. After splash screen is displayed select installation of MotoAdmin.
corresponding message appears restart your computer.
computer. Please confirm selected interface is a parallel interface
and not a 25pin serial one.
stall MotoAdmin software open windows control panel and select Add/Remove pro-
rams.
2.3 Installation of MotoAdmin
Installation of hardware key should be done after s
b
Before starting
tr
Insert CDROM into CDROM drive of computer. The installation now starts automatically.
not use windows explorer, change to CDROM drive letter and run „cdstarter.exe“ d
fr
If
Execution of MotoAdmin is only possible, if the hardware key is attached to the parallel port
(optional USB port) of your
2.4 Uninstallation of MotoAdmin
To unin
g
22.08.2011 Yaskawa Europe GmbH
To Next Page
Loading...
