20 Management functions in main menu
The operator is allowed to do control functions. He can connect to robots (if the robot
configuration is already available), he has the rights to get status information, to read in-
puts and outputs, to read variables and to save robot data files. The Operator Level is the
default level. So no password is needed.
► Programmer Mode:
In addition to the functions the operator can execute, the programmer is allowed to start
robot jobs and to load robot data files.
► Administrator Mode:
The administrator is allowed to do everything which is possible in MotoAdmin.
The passwords can be changed by clicking on the Change password menu item. In the dis-
played dialog the new password must be entered twice. The new password must be entered
twice.
Figure 10 Change password
To change the password your security level must be higher then the level you want to change
the password. So the operator is not allowed to change a password, while the administrator
can change all passwords.
Das erfolgreiche Ändern des Passworts wird mit einer entsprechenden Meldung bestätigt.
Wichtig:
The actions which can be made in operator mode are safe. But if you are logged on with hig-
her security level keep in mind that you are able to move the robot. Do not move the robot if
you cannot see the robot manipulator.
Motoman robotec GmbH is not responsible for damages caused by using MotoAdmin.
Info:
The initial passwords of administrator and programmer level are set to motoadmin.
22.08.2011 Yaskawa Europe GmbH
To Next Page
Loading...
